The Airheads Beemer Club is a non-profit club reclaiming the 'Legendary Motorcycles of Germany'
Please take a moment to read the DISCLAIMER.

Installing an Oil Cooler

Steps are quoted literally from original instructions. Clarifying notes are added where necessary in green font. Send questions or comments to Kent Christensen #1681 at This email address is being protected from spambots. You need JavaScript enabled to view it.

This remainder of this article is only available for Airheads Beemer Club members. Please Log In..or..Click Here to join the Airheads Beemer Club, after which you will enjoy access this article and all members only content of the ABC web site. 

1

Drain off oil.
Unscrew the 3 hex. bolts at the oil-filter cover, take off the cover and remove filter element.
2

Use a screwdriver to unscrew the short tube from the engine block.
Degrease threaded bore (use suitable degreaser).
3

Screw in long tube from conversion kit until it projects only 3 mm from the engine block (insert with Loctite). Take O-ring off short tube and put it on long tube and push it inward with a new filter element.
Note: Centering lugs of filter element must face outward.

Note: Second instruction (take o-ring off ...) here is now irrelevant as o-ring is now attached to filter. In "old days" it was a separate item. Just put in the new filter.
4

Remove O-ring (1) from the old cover.
Take O-ring (2) from conversion kit.
5

Mount oil filter head to engine block with the existing hex. head screws (tighten in several stages). Take out blanking plugs.